Record
The Record page in Calmview gives a full record view showing all fields that
have content. The Record page contains a name in the browser tab, an optional
header and footer, optional additional text in the event of an error message
being shown, and a link to add the item to the basket for document ordering, all of which can be customised.
Here is an example record page in Calmview. Please note: the example screen will open a new window,
when you have finished and wish to return to this page, use the cross in the top right corner to close the window.
The following options are customised using the Record option in the Pages section of the Configurator.
Fields highlighted in red in the Configurator are mandatory.
Page Name
The page name is shown in the browser's
tab for the window in which Calmview is
displayed, in the above example the page
name is "CalmView: Record". To change
this, enter your new text in the Page
Name field and click the
button.
Page Header
By default there is no header on the Record page. To add one, press the
key (in the Page Header field) to directly edit/enter text,
click on the 
button, then the
button. When running Calmview, the header will appear above the
fields of the record and just below the breadcrumb title.
Page Footer
By default there is no footer on the Record page. To add one, press the
key (in the Page Footer field) to directly edit/enter text, click on the
button,
then the button. When running Calmview, the
footer will appear underneath the fields of the record and any underviews.
Add to Basket Link Text
This link is shown underneath the fields in the record and clicking it adds
the item to the 'My Items' basket, ready for document ordering. By default the
text is 'Add to My Items'. To change this, enter your new text in the Add to
Basket Link Text field and click the
button.
Error message pre and Error message post
Various error messages may be shown by the system when running Calmview, for example, if the service has been stopped. These two options enable you to insert additional text to be displayed alongside error messages.By default there is no text shown either side of an error message on the Record page.
To add text in front of error messages, press the
key (in the Error message pre: field) to directly edit/enter text, click on the
button, then the
button.To add text after error messages, press the
key (in the Error message post: field) to directly edit/enter text, click on the
button, then the
button.